// Comodo Site seal

Trail Tough Products * 133 Taft St Medford Oregon 97501*

1-877-SUZUKIS (877-789-8547)

Bad Boy Nerf Bar installation tips

Here are some helpful hints for installing our Nerf bars on your Suzuki Samurai. No welding is required. It does help to have 2 people do the install. Place the nerf bars at about 1" below the rocker panel seam (providing that you do not have a body lift ) - this is best done with a pair of jack stands and a friend. Use a felt marker and mark through the holes on the nerf bar plates to mark your dirlling location on the frame. Start with a small bit 1/4" and then to an oversize bit 1/2" - for adjustment and misalignment purposes. Then mount the nerf bars using the supplied plates as nuts to sandwich the frame stantions.